Purple Raincoat

I did it! Woop! As you can tell I was pretty excited to finish this coat, it is made from a laminated fabric, so it was pretty difficult to manouvre through the machine, but it was totally worth it.

You may remember from my previous post that I made a pattern from an old coat, taking this apart and tracing around the pieces. You can see that here.

A couple of adjustments I made to this pattern were to omit the collar, and replace with a hood. The original coat had a hood attached by buttons underneath the collar. But I never took the hood off, and the collar got in the way of the hood so off it came.

This meant I had to draft the hood as I wanted one that was a little deeper, I hate when the wind picks your hood off your head in the midst of a downpour.

I used a heat activated waterproofing tape to seal the seams, it was a little difficult to get the temperature correct. Some of the tape melted, and some of it didn't attach, but I got there in the end. All I can hope is that it's still ok in there!

The pockets were attached on to the outside, I used the lining piece from New Look 6128. I lined the pocket pieces and then top-stitched them on. I rolled the lining into the centre, so you would see very little of it on the outside.

The seams have been stitched using flat felled seams, this stitches the bulk down on the inside. The triangular pieces at the back and front yoke caused a bit of a headache, but I found that if I snipped off the edge at the point of the triangle, stitched down to the point, and did the same for the other side (rather than leaving the needle in and pivoting) it all went ok.

Oooh shiny green lining. The lining was a little bit complex, I haven't lined a jacket successfully before so I didn't really know what I was doing, but I muddled through. I began by attaching the hood lining to the top of the back facing. I then stitched through the hood to the facing, to secure it in place.

I stitched the sleeve lining pieces to the end of the sleeves right sides together. I then attached the lining to the facings, inside out and stitched the sleeves to the main lining. This meant I had the raw edges of the sleeves showing where I attached it to the main body. I could have had stitched but  was feeling under a bit lazy at the time so I hand stitched bias binding to cover this seam. I then hand stitched the bottom edge of the coat together.

A mistake I made was to put the button holes on the man side of the coat, but you know you win some, you lose some. Feels very odd trying to the close them up on the wrong side though.... as my face shows here.

This definitely counts as a completed challenge, I'm so proud of the coat. It is a spring coat really, I wore it for a week but it was pretty chilly, and a little sweaty in there on a hot bus. Can't wait for the spring! Look here's a dance... do you reckon it will make the spring come early?

Sister feathers dress

As part of my continuing challenge myself to do things plan I've been making clothes for other people. I want to learn all the neat tricks for fitting, as well as getting myself out of my comfort zone of clothes for me. I have specific tastes in clothes, and though that's awesome for me it means I don't get much opportunity to make things that are a bit different. 

My sister has a whole set of completely different clothes/ comfort zone. Check out her pinterest board to see some of her style. So for her birthday I decided that I wanted to make her something special. 

You may have seen this fabric on Charity Shop Chic recently. I also picked this up at the Minerva meet-up recently, which was a fantastic day. I love seeing how people use and interpret fabrics in completely different ways, do you know of anyone else whose used this glorious fabric? Here I have used the fabric in a single layer for a floaty soft garment. The pattern is from Lekala, a rather unusual russian website where you input the measurements and they send you a bespoke dress pattern to print off. I wouldn't use it all the time, but they had a dress that I liked (sans collar) so gave it a go. The instructions were pretty hilarious, basically 1. attach sleeve 2. sew together ha ha.

I won't lie it was a bit of a bugger to sew. I mean sure it slips and slides around a lot which is the usual for this sort of fabric. But unfortunately the print is almost a sort of coating, so when I used my usual thin needle, it was catching threads and pulling. With it being such a dark colour when it pulled it was really obvious with a big white line. Therefore I swapped for a thin stretch needle. Because of the ballpoint, instead of piercing the fabric it slips to the side of the threads thus limiting the number of pulls.

No pattern matching here I'm afraid. Hopefully it will fit and my sis will treat us to a pic of it in all its glory. So nerve wracking sending something off and hoping for the best. Hope you like it sis! 

Mad Men Dress

Ah only fools post about challenges they've nearly finished... or some such sewing based idiom. I did finish my dress in time (promise) but a series of unfortunate technological events contrived against me and the pics weren't ready in time for the challenge showcase! Boo! Ah well ya win some ya lose some. What I won was an awesome By Hand London Anna, proud of how it came out in comparison to my inspiration... and although I missed the challenge here are some Peggy inspired pics.

Hard at work on my latest advertising piece

You can see there's a little bit of bagginess at the back still. I did struggle with the sizing on this dress, it came out far too big on the first go so I kept having to adjust. Ill have to go down a size or two for the next one I think. I also wanted to shorten the skirt pieces, but didn't do it in the pattern stage so made myself some little pleats. I love how they came out as I like a little extra material round the midriff. Anyway, back to work...

Hmm.. what rhymes with Coca-Cola..?

Here are some pics on Betty so you can see some of the details. 

Can you see my picture on the wall? It's the legend that is Captain Picard "Make It Sew", Data and Geordie have sewing machines... it's the best

And if you're interested, oooh look at the pretty insides. I used pre-made bias binding to bind the seams, and hair canvas around the edge to give it a nice standing out skirt. 

Mad Men Dress Challenge... I'm in!

I'm taking part in a sewing challenge, and I'm actually on track for finishing! Can you believe it? I can't ha ha.


The Mad Men Challenge is something I have looked at over the past couple of years and have slathered over all the beautiful dresses that everyone makes. Set up a few years ago by Julia Bobbin the challenge has grown in popularity ever since.


With the end of Mad Men drawing near, I didn't want to miss out on making something inspired by these fabulous ladies.



Julia has posted a lot of amazing inspiration in the past, and some lovely round-ups of those taking part. I started here looking at what people had made, what options there were and then (as is usually the way) found myself on pinterest pinning to my hearts content. You can see my inspiration board here, as you can see I wanted something in the vein of a work dress, as this is where I feel I'm lacking the most in the wardrobe (as discussed in my previous post).

I finally settled on this collared beauty from Modcloth:

My dress therefore won't be a direct Mad Men copy, but Mad Men inspired, as, well, this was my favourite so what ya gonna do?

My version is based on the By Hand London Anna dress, as I felt the lines were very similar. This will be my first make by these amazing independent pattern makers. I am at the moment doing some finishing touches, and will hopefully have some pics to show you by the weekend. 

In the meantime, hope you're enjoying this amazing weather!